These are are subject to alteration at any time. PCB:NG currently supports most common distributors including some manufacturers:

  • Digi-Key
  • Mouser
  • Newark
  • Avnet
  • Arrow
  • TTI
  • Microchip
  • CoilCraft
  • TI

We hope this will allow your creativity to run wild.  We can currently work with parts from other sources, but you'll need to open a ticket with us before ordering.


YES
Passives and LEDs: 0201 (0603 Metric) and up.
YES
 Components with a length or width ≧ 1mm. In other words, if your part is smaller than the outline of an 0201, no bueno.
YES
.4mm Pin Pitch and larger (for non BGA) (see below regarding .4mm Pin Pitch support for non BGA)
YES
 In-stock, cut-tape packaged components from Digi-Key or Mouser with suitable Minimum Quantity
YES
In-stock, tube or tray packaged components from Digi-Key or Mouser with suitable Minimum Quantity (but see here)
YES
 Component heights up to 20mm.
YES
 Component size up to 40mm in any dimension.
YES
 MELFs. Not only do we handle them, but we get a juvenile kick out of the name.
YES
 .4mm Pin Pitch (non BGA). We've upped our game, no problem, no bridges, no problem.
YES
 BGAs at .4mm pitch and up. We can place these parts, but do keep in mind that our PCB constraints make finer pitches difficult to employ.
MAYBE
 Cans, RF Shields and other parts that are placed above previously placed parts.
SPECIAL
User-supplied or consigned components? Please open a ticket, and we'll do our best to make it happen.
NO
 Through-hole; SMT components only. C'mon, all the cool kids are doing SMT now. Hybrid components typically no problem.
NO
 Batteries of any kind. No.
NO
 Parts with "Bake Before Use" recommendation.